OTC

OTC 5044 Self-Adjusting Clutch Rotating Tool Replaces self-adjuster mechanism on Spicer self-adjust clutches

OTC 5047 Lug Nut Cap Remover Chrome-plated lug nut caps found on many heavy-duty trucks and trailers can be tough to remove, and they’re easily damaged if you pry them off or use an...

OTC 5048 1¼" Pilot Bearing Puller These tools make quick work of pulling stubborn, rusted pilot bearings. No. 5048 fits 1¼" I.D. bearings, and No. 5049 fits 1" bearings. The puller's...

OTC 5049 1" Pilot Bearing Puller These tools make quick work of pulling stubborn, rusted pilot bearings. No. 5048 fits 1¼" I.D. bearings, and No. 5049 fits 1" I.D. bearings. The puller's...

OTC 5051 Bearing Puller Set When teamed with our No. 7070A puller, this puller set will remove front and rear countershaft bearings from the main case of Eaton, Fuller, 2 Series Roadranger...

OTC 5052 Brake Slack Checker This tool enables you to quickly check the brake adjustment on class 7 and 8 trucks and trailers having S-cam brakes  Features a sturdy four position handle to...

OTC 5053 Mack Kingpin Socket Here is a socket that makes life a little easier for anyone who works on Mack trucks. Designed for ½" square drive ratchet or breaker bar, the socket fits the...

OTC 5054 Air Brake Service Kit This kit has the tools needed to remove slack adjusters and push-rod clevis pins used in the S-cam brake systems of class 7 and 8 vehicles. Features: Works on...

OTC 5055 Manual Slack Adjust Puller This manual slack adjuster puller will yank even the most corroded slack adjuster off the S-cam — and do so in just a fraction of the time needed with 'heat...

OTC 5056 Automatic Slack Adjust Puller This puller will yank even the most corroded slack adjuster off the S-cam — and do so in just a fraction of the time needed with 'heat and beat" methods...

OTC 5057 Clevis Pin Press Removing corroded clevis pins from a brake air-chamber push rod can be a maddening and time-consuming task — unless you’re using our clevis pin press. This...

OTC 5059 Hub Cap Installer Constructed of high-density polyethylene. Tool guides the cap into place over the axle nuts as the technician taps the cap into place, without damage.

OTC 5060 Detroit Diesel Injector Socket Used on GM 6.2L and 6.5L engines. This 30 mm socket ensures proper fit during nozzle removal and installation. The 3/8" square drive and 7/8" hex permit easy...

OTC 5066 Bearing Driver This tool is designed to install the bearing on 2" diameter input shafts used in Eaton, Fuller, Roadranger transmissions. No. 5066 – Bearing driver. Wt., 5 lbs., 6 oz.

OTC 5068 Truck Tie Rod Socket Designed to withstand the force of a ¾" drive impact wrench, this rugged socket makes truck tie-rod end removal quick and simple.Works on inner and outer tie rod...