OTC

OTC 7490 Spicer U-Joint Easily removes stubborn heavy-duty U-joints on Dana and Rockwell driveshaft assemblies. -Designed for a 1/2" impact wrench, this U-joint tool removes even the most stubborn...

OTC 7491C Control Arm Knockout Tool -Removes the inserts on upper control arm alignment brackets. -Services 1989-current Chevrolet and GMC 1/2-, 3/4-, and 1-ton 2- and 4-wheel drive trucks, and...

OTC 7494A Bearing Remover Set Each of the pullers included in this set make short work removing semi-floating rear axle bearings. The 3 piece set services most domestic cars. Works with OTC...

OTC 7500 Inner Tie Rod Wrench, Standard Universal wrench will fit on all styles and allow the technician to un-screw the tie rod link for replacement. Unique cam design cover sizes from 33-41mm...

OTC 7501 Inner Tie Rod Wrench, Heavy Duty Description: Universal wrench will fit on all styles and allow the technician to un-screw the tie rod link for replacement. Unique cam design cover sizes...

OTC 7502 Spindle Remover Adapter This puller enables you to remove the front spindle on light-duty 4WD trucks. It's designed for full-size Ford, GM, International, and Jeep pickups with Dana front...

OTC 7503HD Heavy Duty Tie Rod and Ball Joint Remover A universal heavy-duty puller that removes a wide range of tie rods and ball joints from a variety of cars, trucks, SUVs and heavy-duty vehicles...

OTC 7507 Universal Inner C.V. Joint Puller No. 7507 – CV joint fork only. Use with OTC slide hammer No. 1155, extension No. 7508, or both.

OTC 7508 Slide Hammer Extension No. 7508 – 17-1/2"-long slide hammer extension.

OTC 7509 CV Joint Tool This tool is a must when you are servicing outer tie rods. It works on imported and domestic models, front or rear wheel drive, cast or stamped-steel knuckles. Pry bars can...

OTC 7544 Strut Rod Nut Socket (24 mm) Description: Strut Rod Nut Socket (24 mm) This specially designed socket is needed to loosen and tighten the top strut nut when servicing the strut spring...

OTC 7588A Cam Bushing Puller Removes rusted and seized bushing before resetting the caster/camber and easily pulls most aftermarket and OE bushings on Ford 4WD vehicles. It's the only tool available...

OTC 7595A Tie Rod Adapter Set Remove and install inner tie rods without removing steering gear. The adapters fit into the tie rod socket, and a 1/2" drive ratchet or breaker bar fits the drive end...

OTC 7612 Toyota Wrench No. 7612 – 54 mm hex socket fits front wheel bearing adjusting nut of Toyota FJ, LN, and RN. Has 1/2" square drive end, permitting use of a torque wrench. 1/2" sq. drive.

OTC 7628 5/16" Fuel Line Fitting Set Features: Fits GM vehicles with 5/16" fuel lines. Will work on low or high pressure TBI systems. Quick, easy, safe. Eliminates makeshift connections that...