Kukko 17-A Separating-set with quick clamping pressure spindle

This 17-A Separating Set is used for removing ball bearings, roller bearings, inner races and other tight parts if there is not enough space to use pulling hooks.

Description:

• 4-parts, the sets contain one separator, one pulling device and a pair of extensions.
• With quick-clamping pressure spindle.
• The sharp blades enable flush parts to be removed where pulling jaws cannot be used.
• The wedge-shaped separator jaws are secured underneath the component to be removed.
• The large supporting surfaces protect the parts to be pulled.
• Instructions on the cover.
• Secure storage in special foam.
• Personal KUKKO-Chip-Code.

Advantage:

• Easy to use, as the separator jaws are quickly and centrally tensioned with just one pressure spindle.
• Ultimate stability when removing, as the separator and pulling device are screwed firmly together.
• Practical package for universal use.
• Complete easy-to-manage package.
• Almost all components available as replacement parts, time-saving order process thanks to numbering system.
• Kit in the tried-and-tested KUKKO-i-Boxx-System.

Specifications:

Content:

• 17-1 Separator with quick clamping pressure spindle
• 18-1 Pulling device
• 19-1-P 2 extensions for pulling devices (pair)

Spare Parts (Sold Separately):

• 618175 Mechanical pressure spindle.
• 17-1 Separator with quick clamping pressure spindle
• 18-1 Pulling device
• 19-1-P 2 extensions for pulling devices (pair)
• 17-1-T Cross-beam
• 18-1-T Cross-beam
• 17-1-06 Spindle
• 017167 Side bolt complete
• 018265 Side bolt complete

How It Works:

• The wedge-shaped separator jaws are secured underneath the component to be removed.
• The separator jaws are prepared by tightening the nuts on the side bolts in equal measure.
• Separate the part by tightening the quick clamping pressure spindle.
• The flat surfaces of the separator blades are used to remove sensitive parts without damaging them. The separator blades provide a larger supporting surface to prevent the parts from twisting.
• For removal, the tension bolts on the pulling device have to be screwed into the separator.
• Note: The clamping depths can be increased using the extensions included in the set.
• The part is removed by tightening the spindle against the end of the shaft.

Safety Information:

• If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time.
• The separator blades' support surfaces must always sit fully beneath the part to be removed.
• Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
• Protective blanket required.
• Protective goggles required.

KUKKO Quality Standards:

• Quality made in Germany.
• Strong design, high performance and long service life.
• Self-healing corrosion protection KUKKoating for galvanized parts (WITHOUT chrom IV).
• Safety label to ensure protection of intellectual property.
• A tube of KUKKO special grease included for pressure spindle.

PLEASE NOTE, IMPORTANT INFORMATION:

• MADE IN GERMANY